3 апр. 2021 г. · I want to configure a 2Gbs LACP/802.3ad (interface bonding) connection from the T410 server to my main 24-port switch (Netgear GS724T).

4 дек. 2015 г. · Make sure the ("slave") interface ( eth0 ) is down before you try to add it to the bond. If it still doesn't work, it's possible your bond mode is not ...

8 авг. 2014 г. · Have you logged in normally, then, or are you at a rescue/single user prompt? (can you switch tty with Alt-F1, Alt-F2 and so on?)

22 окт. 2021 г. · When I'm connected to both the powerline ethernet and the wifi, it will communicate via ethernet. But I want it to use the wifi connection instead.

5 дек. 2019 г. · I made an attempt bonding two interfaces into one, created bond0 , and found it unsatisfactory. I then reverted all changes made to /etc/network ...

7 мар. 2017 г. · The method you're using of assigning an alias IP address bond0:0 is considered deprecated at this point with Linux kernels.

22 мая 2015 г. · The error message was Cannot find device "int0" on the ip link set * up command. And in /var/log/messages I noticed the following messages

12 янв. 2015 г. · It seems that this is because the bond0 interface is not getting a default gateway route, but instead one of the slave interfaces (usually eth3) is getting it.

12 февр. 2018 г. · you set one IP@ to the bound0 but not on its nics. for the nics allocated to bound0 you just say master is the bound0. for example.

12 окт. 2018 г. · To start we're going to construct 3 files. 1 for the bond0 interface, and 1 for each of he 2 interfaces that we're going to use as the slaves (eth2 & eth3).