20 мая 2020 г. · Use wire strippers to expose about 1 inch of the cable. Loosen the screw clamps on the voltage lugs and twist the wire ends. One of the ...

Thread the auxiliary wire cable through the holes in the bottom plate. Separate each pair of wires and strip about 1 inch (1.5 cm) of insulation from each wire.

Продолжительность: 3:48
Опубликовано: 6 февр. 2020 г.

Only use the bottom terminals for wiring to lighting. Do not loosen the top terminals. They are for internal wiring of the transformer. The higher voltage ...

In a small, 75-watt transformer, you will typically find two terminals: one labeled “common” and one labeled “12V.” Landscape lighting uses direct burial cable, ...

Продолжительность: 1:47
Опубликовано: 4 июн. 2017 г.

Feed the low voltage ca- bles through the knockouts, located on the bottom plate. The COMS and voltage TAPS are labeled on each transformer, connect the cables ...

Продолжительность: 23:56
Опубликовано: 22 сент. 2021 г.

There are two types of connectors (Terminal Blocks) in the transformer used to connect wires. The first, Common Taps, are used to connect one leg of each ...

Mount the transformer to a solid surface using the slots in the back of the lid. (Note: the transformer must be mounted at least one foot above ground.