7 июн. 2008 г. · The sequence of "Press Heated Dry, press Normal Wash, then press Heated Dry again and press Normal Wash again (that's 4 button-presses)" worked ...

21 июл. 2019 г. · I have a Quiet Guard 4. Same problem so will describe my solution. 1. Remove bottom basket. Remove top basket. 2. Remove bottom washing arm.

3 Wait for the dishwasher to run a short diagnostic test. 4 Press the "Cancel/Drain" button at the end of the diagnostic test cycle. This should reset the ...

21 авг. 2013 г. · Just hold the Start button for 3 seconds, and it should drain and shut down.

2 апр. 2014 г. · The buttons from left to right are pots/pans, normal wash, water miser, china gentle, quick rinse, high temp, air dry, delay wash, start. What ...

3 янв. 2019 г. · Press the following sequence of control panel buttons in quick succession: "Heated Dry," "Normal Wash," "Heated Dry" and "Normal Wash." Allow ...

I entered the control panel mode The sequence I used was: Hi Temp Wash, Heated Dry; Hi Temp Wash, Heated Dry. This did clear the blinking light and the ...

4 нояб. 2013 г. · On our Kenmore Quietguard the lock light is at the Air Dry button. Holding the Air Dry button for about 8 seconds turns the lock light off if it ...

20 февр. 2011 г. · Press andhold the "Heated Dry" button on your Kenmore dishwasher for fourseconds to unlock the dishwasher control panel. Press the"Heated ...

3 сент. 2012 г. · Sorry I figured out myself. Push the rinse-hold button, then regular wash after each other about 5 times. It just started right up. Thanks for ...