12 дек. 2009 г. · The iostat man page says: tps Indicate the number of transfers per second that were issued to the device. A transfer is an I/O request to the device.

28 мая 2018 г. · I'm going to assume this is a SATA disk system so 181 TPS is about the limit. You can try iostat -x 1 to get some extended statistics ...

1 дек. 2013 г. · The first report generated by the iostat command provides statistics concerning the time since the system was booted. Each subsequent report ...

3 июл. 2014 г. · I'm attempting to get IOPS for my Solaris servers. Typically I use tps for this calculation, however: iostat gives TPS but only for local disks.

12 мар. 2010 г. · It appears you have 72.22% iowait(time spent by a process while waiting for disk I/O to complete) which is likely why the file move is slow.

27 янв. 2015 г. · Why the tps differs significantly for md0 and the other hard drive? When running with internal set (iostat 1), the reads are usually on only ...

16 янв. 2021 г. · I'm trying to understand this iostat output: tps kB_read/s kB_wrtn/s kB_dscd/s kB_read kB_wrtn kB_dscd Device 500.30 58.9M 19.4k 0.0k 329.1G ...

24 окт. 2011 г. · I need to log disk statistics (MB/read, MB/write) of block devices. As I understand, iostat shows an average value. This is not exactly what I want when I'm ...

23 авг. 2012 г. · I need to be able to get all those column in realtime without outputing to a file or running iostat twice since that would give misleading results.

2 окт. 2018 г. · Running a typical process on the drive yields (via iostat ) about 75MB/s write, with about 5K TPS (IOPS). iostat also shows disk utilization ...