12 февр. 2013 г. · JNZ is short for "Jump if not zero (ZF = 0)", and NOT "Jump if the ZF is set". If it's any easier to remember, consider that JNZ and JNE (jump if not equal) ...

13 дек. 2022 г. · The jnz instruction means "jump if the z flag is not set". When dx is 4, and you compare it to 0, the z flag will not be set, so the jump is ...

10 янв. 2013 г. · JE and JZ are just different names for exactly the same thing: a conditional jump when ZF (the "zero" flag) is equal to 1.

11 июн. 2020 г. · The special symbol . refers to the current address that as is assembling into. In the context of code, . is the address of the current instruction.

6 нояб. 2016 г. · Подскажите, пожалуйста, где почитать документацию по ассемблерным вставкам в код на C++. Например что означает выражение в операнде: jnz $+11 .

25 сент. 2013 г. · JNZ is jump if not equal to zero, it will jump or not depending on whether ZF is set to 1 or not. If it's 1, it will not jump. Else, it will ...

22 мар. 2014 г. · We code jnz target and it disassembles as jnz address_of_target but if you look at the bytes emitted, it's "distance to target" not the address.

17 янв. 2011 г. · Т.е., здесь "shr A" выполнится в delay slot предыдущей инструкции бранчевания "jnz loop", что позволит нам сэкономить 'B' операций. Для RISC ...

2 дек. 2016 г. · The problem is that in loop called PETLA_GWIAZD when I subtract ax 2nd time it's value is 0, which is causing the infinite loop.

20 нояб. 2013 г. · It checks zero flag in status (FLAGS) register. To see which instructions modify this flag, see x86 software developers manual.