23 февр. 2010 г. · In windows you can add a route based on the interface without knowing the gateway by passing 0.0.0.0 as gateway. this gives something like ...

20 апр. 2018 г. · I toyed around with route add in windows, however, it does not allow a route to be added without gateway IP address specified. I can specify ...

1 дек. 2016 г. · When I add the static route to the table, it doesn't show the specified interface, only associate it to the gateway. screenshot 2. Is it correct ...

3 февр. 2021 г. · You can add on-link routes via a specific interface without explicitly mentioning the gateway address using the following syntax:

28 янв. 2014 г. · Put the default gateway only on one interface. Then with static route, direct the traffic you want to go via the other interface. For ...

9 дек. 2009 г. · The command you're looking for is route add: route | Microsoft Docs. For your setup, I think the syntax is: route add 10.183.0.0 mask ...

15 февр. 2018 г. · You should run the command as administrator, I use my route commands as: route add [HOST] MASK 255.255.255.255 [GATEWAYIP] route add [NET] ...

11 янв. 2013 г. · So the first one is on a class A subnet, the second is on a class C subnet. This is what my routing table looks like: Destination Gateway ... Не найдено: windows | Нужно включить: windows

21 авг. 2023 г. · In general terms you can't have more than one active default gateway, so in your case NIC1 has clearly been selected as the default.

6 янв. 2010 г. · Well I am doing exactly the same and Windows 8 insists in using the "LAN" gateway... instead of the "WLAN" gateway. So, not sure is Windows ...